Diy: boat trailer bunk setup by mike schoonveld when you think of the important parts of a boat trailer, it’s easy to pick out the wheels and bearings, the lights and clearance markers, perhaps the brakes or even the coupler where the trailer hooks to the tow vehicle.. Re: how to set up the trailer? on my trailer with rollers and bunks the rollers support the forward portion and the bunks the rest probably about 60 to 80 percent.with a smaller boat the percentage of weight is higher at the stern what with the motor etc back there.bunks should stick out a little past the transom enough so if it shifts back a little the bunks are still under the transom.. Trailer set-up covers things like roller and skid set-up and position, when to use rollers or skids (see previous issues of vfm for more information), the position of the boat on the trailer and the position of the suspension to ensure the correct draw bar weight..
Rollers are a great system for all boats, and as the name suggests they allow you to roll the boat off and on the trailer. there are 3 different types of roller setup you will find on a trailer, depending on the make, shape and weight of the boat.. A. set boat on trailer while maintaining no less than 2" gap between keel and tongue plate cover. the end of the bunks/rollers should be flush with transom and the boweye should reach the winch post.. Instructions for fitting a boat to a new venture aluminum bunk trailer: 1. make sure your tow vehicle has the right ball size [2" for singles and small tandems. 2 5/16" for tandems over 6,000 # boat load capacity and all triple axle trailers..
0 komentar:
Posting Komentar
Catatan: Hanya anggota dari blog ini yang dapat mengirim komentar.